Fan PCB With Remote

Description

The Original Aideepen Universal Fan Remote Control Modification Board is an all-in-one electronic upgrade kit designed to convert standard manual electric fans into fully remote-controlled appliances. Perfect for repairing broken fan motherboards or retrofitting older models, this compact main control board adds modern convenience to your home cooling setup. The kit comes complete with a main receiver PCB motherboard featuring a built-in buzzer alarm for audio feedback, an infrared (IR) receiving sensor line, and a sleek, multi-function handheld remote control. It introduces advanced digital features including multi-speed regulation, natural wind mode simulation, swing/oscillate logic, and an automated sleep timer adjustment. Technical Specifications & Features Operating Voltage: AC 220V–230V, 50/60Hz Maximum Load Capacity: Under 100W (Optimized for standard home cooling motors) Speed Adjustments: 3 Distinct speed steps (Low, Medium, High) Integrated Timer: Programmable automated shutdown intervals (1-hour, 2-hour, 4-hour, and 7.5-hour increments) Convenience Modes: “Continuous Blowing”, “Natural Wind Mode” (simulates real gusts by varying fan speed), and “Smart Sleep Mode”. Compatible Fan Types & Appliances Because this is a Universal AC Fan Controller Board, it is not limited to a specific brand. It can be hardwired into almost any standard household electric fan that utilizes a multi-tap mechanical speed switch or standard multi-wire AC motor layout, including: Stand / Pedestal Fans: Easily replaces the manual push-button base switches on traditional standing floor fans. Wall-Mounted Fans: Ideal for high-wall fans, eliminating the need to pull cords or manually reach up to alter speeds. Table & Desk Fans: Restores full functionality to office table fans with burnt-out mechanical switches. Evaporative Air Coolers: Can be retrofitted into small cooling fans or water-evaporative air coolers, provided the combined pump and fan load does not exceed 100W. ⚠️ Installation Safety Notice: This modification board is connected directly to 220V high-voltage mains electricity. Ensure your power source is completely disconnected before attempting installation. The output lines are strictly designated for standard multi-wire speed configurations (COM for Common, 1 for Low, 2 for Medium, 3 for High, and SW for the separate swinging motor). Connecting wires incorrectly will cause a short circuit and instantly burn out the PCB board.